APIX2 BOARDS & TOOLS
APIX2 Boards
Tool |
Description |
Order ID: |
price |
|---|---|---|---|
INAP375T APIX2 Transmitter main board, 2x HDMI/DVI 24bit video input, HSD APIX2 serial link output, USB control interface, audio input (optional) |
APIX2_ADK_TX |
€ 1499.- |
|
INAP375R APIX2 Receiver main board, 1x HDMI output, HSD APIX2 input, HSD APIX2 output for daisy chain, USB control interface |
APIX2_ADK_RX_HDMI |
€ 1499.- |
|
INAP375R APIX2 Receiver main board, 2x LVDS output, HSD APIX2 input, HSD APIX2 output for daisy chain, USB control interface |
APIX2_ADK_RX |
€ 1499.- |
|
INAP395R APIX2 Receiver main board, supports HDCP copy protection, HDMI output |
APIX2_ADK_INAP395R |
€ 1499.- |
|
INAP375T Extender Board |
I/O Extender Board for direct access to INAP375T pins. Fits to APIX2_ADK_TX |
APIX2_ADK_TX_EXT |
€ 159.- |
INAP375R Extender Board |
I/O Extender Board for direct access to INAP375R pins. Fits to APIX2_ADK_RX and APIX2_ADK_RX_HDMI |
APIX2_ADK_RX_EXT |
€ 159.- |
INAP375T/R Ethernet Board |
APIX2 Ethernet Extender Board for Transmitter and Receiver Main board, 3-port 100 Mbps Ethernet switch, allows to access MII interface of INAP375x device. Fits to APIX2_ADK_TX, APIX2_ADK_RX and APIX2_ADK_RX_HDMI |
APIX2_ADK_ETH |
€ 249.- |
APIX2 In-System Configuration board allows to interface with INAP375T and -R in any application. |
APIX2_PROG |
€ 399.- |
|
ADK_HSMC |
€ 499.- |
APIC2 Camera Kits
Tool |
Description |
Order ID: |
price |
|---|---|---|---|
APIX2 Camera Demo, based on SMS OV10635 fully sealed Camera with INAP378TAQ and INAP375R |
APIX2_CEK_OVT |
€ 1999.- |
APIX1 Boards
Tool |
Description |
Order ID: |
price |
|---|---|---|---|
INAP125T/R APIX Demonstration Kit with DVI in/out, RS232, Rosenberger HSDConnector |
APIX_ADK_HSD |
€ 375.- |
Software
Tool |
Description |
Order ID: |
download |
|---|---|---|---|
Software Tool to configure APIX2 devices, configuration wizard, dependency check, plausibility check, status registers, etc. |
n/a |
||
APIX2 Native |
The APIX2Native utility provides a user interface to build commands based on the “Native Command mode”, prepared to provide a simple UART interface to control the INAP375T/R APIX2 transmitter and receiver devices at the APIX2_ADK demonstration kits. The following functionalities are supported by the software: |
n/a |